This leaf/ petal can be made freehand or by using a comb. I have given both methods here. Try to look at the pics and understand the method before reading the instructions.
Comb Method
1
Take a large comb (use the side with a wider gap between the teeth) and a 3mm strip of your choice and make a loop around the last tooth and glue it shut.
2
Now thread the strip under the next tooth and bring it back up as shown in the pic above.
3
4
Next, fold it forward as shown in the 1st pic above making sure it is aligned on top of the other loops you have made and thread it under the next tooth as shown in the 2nd pic above.
Continue making about 5 to 6 loops (the size and number of loops will depend on the size of the comb. Large combs with more space between the teeth will give you larger leaves).
5
Remove from comb and leave the balance strip to wrap around the leaf or tear off excess.
6
Quill another half leaf in another color and get the same number of loops. Then glue them together as shown above then glue another strip you want to use to wrap round the leaf, to the bottom as shown.
7
Now apply a wee bit of glue to the edge of each loop of one color and glue it to the loops of the other color gently and wind the strip around to encircle the leaf.
That it folks!!
Manual Method
The leaves made by hand will look less symmetrical like it does in nature. To make sure that the loops of the two halves are the same sizes both strips should be shaped together.
Make a loop holding both strips together. Do not paste the strips together.
Fold the loop forward at the place the loop starts.
Make the second loop so that it overhangs the 1st loop. Size it by using your third finger to push it over the 1st loop as shown.
Once again fold it forward and create the 3rd loop and push it over the second loop as shown to size it. Continue in this manner till you reach the size of the leaf/ petal you desire.
Separate the 2 strips and it should look like the pic above.
Now apply a tad of glue at the top (not the tip) of each fold as shown in the picture and you have made the 2 halves of your leaf/petal.
This is what your half leaves will look like.
Now glue both the half leaves at the bottom as shown.
Apply glue to the top of each loop of one of the halves as shown.
Glue the loops as shown to make the leaf. do not squash it. Gently hold them till they get stuck and then encircle the leaf with another strip of your choosing and your done.
Just a tiny request to those of you who use this leaf , please give a link to this blog so that others may learn too.
0 nhận xét:
Đăng nhận xét